Gratis · Rekenen en converteren
Tapboor.
Schat de boordiameter uit de nominale diameter, de spoed en het draadpercentage.
Drill = major − pitch × (percent / 75). At 75% this matches the common one-pitch chart rule. It is a shop estimate, not a gauge inspection. Local arithmetic only. This is a quantity or geometry estimate, not a code check and not a substitute for a licensed professional.
- Tap drill
- 8.5 mm
Drill diameter = major diameter − pitch × (thread percent / 75). At 75% this is the common chart rule of one pitch under the major diameter. It is a shop estimate, not a thread-gauge inspection.
Zo gebruik je deze tool: Tapboor
Voer gegevens in of kies een bestand. Pas de instellingen aan, maak het resultaat en controleer het voordat je het kopieert of downloadt.
Limieten en ondersteunde formaten
Je invoer wordt op je apparaat verwerkt.
Technische opmerkingen in het Engels
Drill = major − pitch × (percent / 75). At 75% this matches the common one-pitch chart rule. It is a shop estimate, not a gauge inspection. Local arithmetic only. This is a quantity or geometry estimate, not a code check and not a substitute for a licensed professional.
Estimate a tap drill from the major diameter, pitch and a thread percentage. Drill = major − pitch × (percent / 75). At 75% this matches the common one-pitch chart rule. It is a shop estimate, not a gauge inspection. Local arithmetic only. This is a quantity or geometry estimate, not a code check and not a substitute for a licensed professional.
M10 × 1.5 at 75% thread → 8.5 mm.